This is the mail archive of the
cygwin@cygwin.com
mailing list for the Cygwin project.
Re: ddd and xemacs wont't work with post 1.1.4 dll
- To: <earnie_boyd at yahoo dot com>
- Subject: Re: ddd and xemacs wont't work with post 1.1.4 dll
- From: Thomas Pfaff <tpfaff at gmx dot net>
- Date: Tue, 29 May 2001 10:56:24 +0200 (Westeuropäische Sommerzeit)
- cc: <cygwin at cygwin dot com>
earnie_boyd@yahoo.com wrote:
> Thomas Pfaff wrote:
>
>> On 23 May 2001, Andrew Markebo wrote:
>>
>>
>>> / Thomas Pfaff <tpfaff@gmx.net> wrote:
>>> | Hi all,
>>> |
>>> | it may be that this is already known but there are 2 problems that
does
>>> | not allow me to upgrade my cygwin installation:
>>> |
>>> | 1. ddd does not work with any cygwin dll post 1.1.4. When ddd tries
to
>>> | start gdb it does a fork and exec, but the child ddd stops after the
fork
>>> | consuming the whole cpu time.
>>> |
>>> | 2. Same when building xemacs 21.1.14, when temacs starts to compile
the
>>> | .el files it stops consuming the whole cpu time.
>>>
>>> is it ddd built with post 1.1.4 or pre 1.1.4, there could be a
>>> difference in libraries and so on?
>>
>> I started building with 1.1.8, then i went back until 1.1.4 which was
>> working.
>>
>
>
> You'll have to at least try 1.3.2 to determine if it's still broke. If
> 1.3.2 doesn't work then you'll need to install the latest cygwin-inst
> snapshot from the http://cygwin.com/snapshots/ page to see if it's been
> recently fixed. Then if it still doesn't work, it's still broke.
Sorry for the delay but i was off for some days.
I had tried with 1.3.2-1 and now i downloaded cygwin1-20010525.dll but ddd
does still not work.
I can see two ddd processes in the taskmanager, the original one and
the forked consuming all remaining cpu time but unable to exec gdb.
I am using ddd-3.3 with lesstiff 0.92.6, build with 1.1.4. I have not
rebuild ddd from source, i only replaced the dll.
Thomas
--
Want to unsubscribe from this list?
Check out: http://cygwin.com/ml/#unsubscribe-simple