This is the mail archive of the
cygwin@sourceware.cygnus.com
mailing list for the Cygwin project.
Re: Cygwin1.dll (1.1.2) CRLF
- To: cygwin at sourceware dot cygnus dot com
- Subject: Re: Cygwin1.dll (1.1.2) CRLF
- From: Chris Faylor <cgf at cygnus dot com>
- Date: Thu, 8 Jun 2000 01:43:01 -0400
- References: <003a01bfd10b$734b1890$2d91a5d8@msrv>
- Reply-To: cygwin at sourceware dot cygnus dot com
There is a specific mount command.
The documentation for the mount command can be found at the project web
site:
http://sourceware.cygnus.com/cygwin/
Or, you can peruse the 525,637 other email messages where it has been
mentioned in the past.
cgf
On Thu, Jun 08, 2000 at 12:36:07AM -0500, Joe Hagen wrote:
>I'm running on WinNT 4.
>
>I've used the Cygwin B19 and B20 releases in the past.
>
>I decided to use setup.exe and obtain the various gcc
>packages (2.95.2), and Cygwin1.dll (1.1.1).
>
>My makefiles stopped working, and I determined it was
>because they were using \r\n instead of \n line terminators.
> If I run MAKE (v. 3.77), it says
>
> *** No targets. Stop
>
>I thought version 1.1.2 of the DLL would take care of
>the problem, but I'm experiencing the same behavior
>after downloading/installing it.
>
>Is there a specific MOUNT command that I would have to
>use in order to make this work, or is this \n behavior
>in makefiles intentional.
>
>With the Cygwin B releases, I could use CRLF terminated
>lines, which is more convenient on a Win host.
>
>Thanks much.
>
>Joe
>jdhagen@chorus.net
>
>
>
>--
>Want to unsubscribe from this list?
>Send a message to cygwin-unsubscribe@sourceware.cygnus.com
--
cgf@cygnus.com Cygnus Solutions, a Red Hat company
http://sourceware.cygnus.com/ http://www.redhat.com/
--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe@sourceware.cygnus.com